The engineer will check a few things when you have your annual gas boiler service. The engineer may not follow the boiler service checklist exactly, but it’s fine as long as they follow all the steps and provide you with a boiler certificate that proves that your boiler was serviced.
- Visual Inspection
After you’ve shown the engineer where your boiler is located in your home, they will begin by performing a visual examination of the system. The engineer will then inspect the hot water cylinder of the boiler, the connecting pipes and the control panel according to the manufacturer’s specifications.
The technician will also verify that the fuse rating of your boiler is correct. The fuse can be set too high and cause dangerous overheating.
- Firing up
The engineer will start your boiler if it’s not already on to ensure it starts heating water efficiently. Then, they will isolate the problem using electrical testing equipment.
- Casing Removal
After the engineer has completed the visual inspection of the boiler, they will remove its casing in order to perform a thorough internal check. The engineer will examine a number of things after removing the casing.
The technician will check for obvious faults or weak points, such as corrosion and gas leaks. They will also check the pilot light, which is the flame of the boiler. For Boiler Service Cheltenham, visit http://www.combi-man.com/
- Flue check
Your boiler’s flue will be checked by the engineer. The pipe leading from your boiler outside your home is called the flue. The technician will check to see that the flue is properly fitted and that it’s free of obstructions or blockages that might prevent water from flowing easily.
- Gas pressure checks
The boiler must always have the right gas pressure. The water in taps and radiators will not heat to the right temperature if the pressure is incorrect. The engineer will check the manufacturer’s instructions and ensure that your boiler is correctly pressurised.
- Additional Checks
The engineer will check that all controls and functions of the boiler are functioning properly. The engineer will also test any safety devices and make sure they work properly.
- Reporting
The engineer must keep a log of all tests they perform on the boiler. This should include the results and faults that were found. This report will let you know if anything needs to be addressed.
This document will help the future engineer to be aware of any issues that may have occurred in the past and what they should look out for.
Leave a Reply